Technical data

Replacing 6000A Assemblies 5
6000 Series Oscilloscopes Service Guide 129
To remove the power supply
1 Perform the previous procedures:
• “To remove the cabinet” on page 104
• “To remove the power supply shield” on page 125
2 Disconnect the power supply and AC cables.
3 Remove the 4 T10 screws securing the power supply to
the deck. then remove the power supply.
Figure 39 Removing the power supply
4 Reverse this procedure to install the power supply.
T10 Screws (4)
Power Supply Cable
Power Supply
AC Cable
6000_series_service_guide.book Page 129 Friday, March 23, 2007 2:43 PM