Technical data

Replacing 6000A Assemblies 5
6000 Series Oscilloscopes Service Guide 107
To remove the front panel assembly
1 Perform the following procedures:
• “To remove the cabinet” on page 104
2 Insert a flat- blade screwdriver under the center of the
intensity knob and gently twist it as you pull the knob off.
Using a twisting motion rather than prying prevents
marking or damaging the front panel.
3 Remove the T6 screws securing the BNC assembly to the
deck.
This step helps prevent the BNC connectors from binding
when removing and reinstalling the front panel.
Figure 20 Removing the intensity knob and T6 screws
4 Disconnect the keyboard ribbon cable from the keyboard.
5 Use a flat- blade screwdriver to the release retainer tabs
and then push the panel forward.
Ensure that the retainer tab on the display side moves
past the rear edge of the display mount.
Intensity
Knob
T6 Screws (3 or 4)
6000_series_service_guide.book Page 107 Friday, March 23, 2007 2:43 PM