Technical data

Replacing 6000A Assemblies 5
6000 Series Oscilloscopes Service Guide 105
To remove the handle
If you are mounting the instrument on a rack, you will
probably need to remove the handle.
1 Rotate the handle downward until it just passes the last
detent position; this is about 1/2 inch before the handle
touches the bottom of the oscilloscope.
2 Pull the sides of the handle out of the cabinet and
remove.
Figure 18 Removing handle
6000_series_service_guide.book Page 105 Friday, March 23, 2007 2:43 PM