Technical data

104 6000 Series Oscilloscopes Service Guide
5 Replacing 6000A Assemblies
To remove the cabinet
1 Turn off the oscilloscope and disconnect the power cable.
2 Using the T20 TORX driver, remove the two screws from
the rear of the cabinet.
3 Using your thumbs, gently push on the rear- panel
connectors to slide the oscilloscope out of the cabinet.
Figure 17 Removing the cabinet
T-20 Screw
T-20 Screw
Gently push
on the connectors
6000_series_service_guide.book Page 104 Friday, March 23, 2007 2:43 PM