Technical data

100 6000 Series Oscilloscopes Service Guide
4 Troubleshooting
• Vertical - Channel 1 on, 5 V/div scale, dc coupling, 0 V
position, probe factor to 1.0 if an AutoProbe probe is
not connected to the channel
• Trigger - Edge trigger, Auto sweep mode, 0 V level,
channel 1 source, dc coupling, rising edge slope, 60 ns
holdoff time
• Display - Vectors on, 20% grid intensity, infinite
persistence off
• Other - Acquire mode normal, Run/Stop to Run, cursor
measurements off
Figure 16 Default setup screen
3 If your screen looks substantially different, replace the
system board.
6000_series_service_guide.book Page 100 Friday, March 23, 2007 2:43 PM