Technical data

10 6000 Series Oscilloscopes Service Guide
Figures
Figure 24. Removing the main shield and disconnecting the display
cables 114
Figure 25. Removing the display assembly 115
Figure 26. Installing the display 116
Figure 27. Opening the backlight inverter shield 117
Figure 28. Removing the backlight inverter 119
Figure 29. Removing the backlight inverter shield 120
Figure 30. Closing the shield 121
Figure 31. Release display mount latches 122
Figure 32. Removing the LCD, gasket, and protective lens 123
Figure 33. Latch over face of sheet metal housing 124
Figure 34. Release hook legs from deck. 125
Figure 35. Dielectric insulator tape. 126
Figure 36. Proper angles for tabs and hook legs. 127
Figure 37. Tilt to insert tabs. 127
Figure 38. Insert hook legs and lock in place. 128
Figure 39. Removing the power supply 129
Figure 40. Removing the power shaft latch 130
Figure 41. Removing the AC input board 131
Figure 42. Removing the batteries 133
Figure 43. Removing the battery controller board 136
Figure 44. Removing main shield and disconnecting fan
cable. 137
Figure 45. Removing the fan 138
Figure 46. Preparing to remove the system board 140
Figure 47. Removing the system board 141
Figure 48. Removing the cover 145
Figure 49. Removing the intensity knob 146
Figure 50. Disconnecting ribbon cable and releasing tab
retainers 147
Figure 51. Preparing to remove the system board 149
Figure 52. Avoid damage to thermal pads (500 MHZ models
only) 149
6000_series_service_guide.book Page 10 Friday, March 23, 2007 2:43 PM