Operating instructions

Language Dictionary
36
Command Syntax
*RCL <NRf>
Parameters
0 through 6 where:
States 1-6 Volatile states previously stored by *SAV
State 0 Nonvolatile state previously stored by *SAV 0
Suffix
None
Related Commands
*RST *SAV
*RDT Resource Description Transfer Query
Type
Device Specification
Description
This query returns the model number of a single electronic load or the model number of the
module installed in each channel of a multiple electronic load. For multiple electronic
loads, a semicolon (;) separates each module and the string terminated with a LF (line feed).
Query Syntax
*RDT?
Returned Parameters
< aard> String value as follows:
single electronic load CHAN1:nnnnL; where “nnnnL” = model number
multiple electronic load CHAN <c>:nnnnnL; where “c” = channel number and
“nnnnnL” = number and suffix letter of the module in that
channel.
Related Commands
*IDN? *OPT?
*RST Reset Command
Type
Device State
Description
This command sets the electronic load to its factory-defined state. (Refer to “Factory
Default Settings” in the Operating Manual of the electronic load model that you are
programming.) There are no parameters with this command; it sets all channels of the
multiple electronic load to the same state.
*RST also does the following:
■ Forces an ABORt command before resetting any parameters.
■ After all parameters have been reset, executes an INP:PROT:CLE to clear the
electronic load’s protection circuits.
Note
*RST does not affect any Status Enable registers or Transition Filters.
Command Syntax
*RST
Parameters
None
Related Commands
*RCL *SAV