Specifications
Overview
8
Related Documents
The following documents are related to this manual:
Manual Part Number
Description
Agilent 66000A MPS Mainframe
Installation Guide
66000-90001
Provides product specifications, installation, and
connection information.
Agilent Series 6610xA MPS Power
Modules User's Guide
5959-3386
Describes the operation of the MPS Power Modules.
Agilent Series 6610xA MPS Power
Modules Programming Guide
5959-3362
Describes SCPI programming commands, status
reporting.
Agilent Series 66000A MPS
Mainframe Service Manual
66000-90003
Provides replaceable-parts lists, circuit diagrams, and
verification procedures for the Agilent Series 66000A
MPS Mainframe.
Revisions and Updates
Manual
Agilent Technologies instruments are identified by a 10-digit serial number. The format is described as follows: first two
letters indicate the country of manufacture. The next four digits are a code that identify either the date of manufacture or of a
significant design change. The last four digits are a sequential number assigned to each instrument.
Item Description
US The first two letters indicates the country of manufacture, where US = USA; MY = Malaysia; SG = Singapore.
3648 This is a code that identifies either the date of manufacture or the date of a significant design change.
0101 The last four digits are a unique number assigned to each power module.
If changes have been made to your unit since the publication of this manual, a yellow Manual Change sheet may be supplied
with the manual. It defines the differences between your unit and the unit described in this manual. The yellow change sheet
may also contain information for correcting errors in the manual. Note that because not all changes to the product require
changes to the manual, there may be no update information required for your unit.
Older serial number formats used with these instruments had a two-part serial number, i.e. 2701A-00101. This manual also
applies to instruments with these older serial number formats. Refer to Manual Backdating for backdating information.
Firmware
This manual applies to power modules that run on software revision A.00.01 through A.00.04. Firmware revision A.00.04 is
backward compatible with all previous revisions. The ROM chip (U2) has a label that specifies the firmware revision.