Specifications

605xA and 606xB: Electronic Load Slew Rate
Question: What are the units used when setting the slew rate on the electronic loads?
Answer: When setting the slew rate from the front panel of the load, the units used are A/us. When setting the slew
rate over the GPIB, the units used are also A/s.
The range of slew rate that can be programmed varies depending on which output range (high or low input current),
and the model. As an example for the 6060B, on the low range (0-6A), slew rate can be programmed from 1A/ms
(0.001A/us) to 5A/us. On the high range (0-60A), slew rate can be programmed from 0.1A/ms (0.0001A/us) to
0.5A/us. The ranges of slew rate for all electronic load products can be found in the Supplemental Characteristics
section of the electronic load pages of the Power Products Catalog.