Operator`s manual

Troubleshooting and Maintenance 5
100 Operator’s Manual 47
Printer Configuration
1 Turn off the 100.
2 Press and hold the printer toggle switch in the OnLine / Off Line
position while turning on the instrument. Hold the printer toggle
switch in the OnLine / Off Line position for six seconds after the
instrument is turned on, then release the switch.
3 The printer should print: ***
SETUP MENU *** and CONFIGURE...
[
NEXT/OK]. If this message does not print, repeat steps 1 through 3.
4 The printer toggle switch is used to complete the configuration.
Pressing the left side of the printer toggle switch selects
NEXT to
advance to the next menu item. Pressing the right side of the printer
toggle switch selects
OK to accept what is stated on this line of the
menu item. Each time the switch is pressed, another part of the menu
prints. Allow the printer to finish printing before pressing the switch
again. See the table of commands on the following page.
NOTE
The printer configuration is set by the factory. This procedure should be
performed only if the printer displays erroneous characters. Contact the
Dissolution Systems Service Department for assistance, if necessary.
NOTE
The printout is easier to read if the printer cover is removed.