Operator`s manual

28 100 Operator’s Manual
4 Operating the 100
Setting Water Bath Temperature
To set the water bath temperature, press SET TEMP. Enter the desired
water bath temperature and press ENTER.
Setting Print Frequency for the Report Center Printer
If your 100 is equipped with a Report Center Printer and you want an
automatic periodic printout of test conditions, enable the built-in Report
Center Printer and indicate the desired automatic print interval.
To enable the printer, press PRINT FREQ. Enter the desired auto-print
interval in mmm format up to 255 minutes and press ENTER.
To disable the printer, enter an auto-print frequency of 0 (zero) and press
ENTER.
NOTE
It may be necessary to set the water bath temperature up to 0.5 °C higher
than the desired temperature of the medium in the beakers to
compensate for heat loss through the walls of the beakers.