Operator`s manual

24 100 Operator’s Manual
3 Setting Up the 100
The Ext Temp Probe LED illuminates when the external temperature
probe reading displays in the temperature screen. Otherwise the internal
probe reading displays.
The Printer On LED illuminates when the Report Center Printer has
been enabled.
Setting the Date / Time Clock
If you are using the built-in Report Center Printer to document the test
conditions, you must set the correct date and time. This information
displays on all printouts.
To set the date and time, complete the following steps:
1 Press SET CLOCK. The Position 3 screen flashes the date.
2 If the date is correct, press ENTER. Otherwise, enter the correct date
in mm/dd/yy format and press ENTER. The time flashes.
3 If the time is correct, press ENTER. Otherwise, enter the correct
time in 24-hour format and press ENTER.
NOTE
If the external temperature probe is not connected, the temperature
display reads 4.4. This is normal and changes as soon as the probe is
installed.