Installation manual

5975 Series MSD Operation Manual 7
To measure column flow linear velocity 73
To confirm column flow 74
To tune the MSD 75
To verify system performance 76
High-Mass Testing (5975 Series MSDs) 77
To remove the MSD covers 80
To vent the MSD 82
To open the analyzer chamber 84
To close the analyzer chamber 87
To pump down the MSD 91
To move or store the MSD 93
To set the interface temperature from the GC 95
4 Operating in Chemical Ionization (CI) Mode
General Guidelines 98
The CI GC/MSD Interface 99
To Operate the CI MSD 101
To switch from the EI source to the CI source 102
To pump down the CI MSD 103
To set up the software for CI operation 104
To operate the reagent gas flow control module 106
To set up methane reagent gas flow 109
To use other reagent gases 111
To switch from the CI source to the EI source 115
CI Autotune 116