Specifications

106 5975 Series MSD Troubleshooting and Maintenance Manual
4 General Maintenance
To Reconnect the MSD to the 6850 GC
Materials needed
Wrench, open-end, 1/4-inch 5/16-inch (8710-0510)
Screwdriver, Torx T-15 (8710-1622)
Procedure
1 Position the MSD so that it is near the GC.
2 If not installed, install the GC/MSD interstitial panel (part number
G2589-00031) onto the midsupport and front-support legs of the right side
of the MSD. Use three M4 T-15 screws. See Figure 10.
Figure 10 GC/MSD interstitial panel mounting holes (turbo pump shown)
Mounting holes