Specifications

To use oscilloscope channels to view a signal
•
To configure the instrument quickly, press
Autoscale
.
•
To undo the effects of autoscale, press
Setup
, then press
Undo
Autoscale
.
•
To set the instrument to the factory-default measurement
configuration, press
Setup
, then press
Default Setup
.
Example Connect the oscilloscope probes for channels 1 and 2 for HP 54645A (or
A1 and A2 for HP 54645D) to the calibrator output on the front panel of
the instrument. Set the instrument to the factory default configuration by
pressing
Setup
, then Default Setup. Then press
Autoscale
. You
should see a display similar to the following.
HP 54645D Sample Autoscale Measurement
Figure 2-3
Front-Panel Overview
To use oscilloscope channels to view a signal
2-17