Specifications

To remove the keyboard
1
Remove the front panel.
2
Remove all the knobs by pulling straight out.
3
Flex the bezel of the front panel to unsnap the small keyboard under
the display opening.
4
Using the T10 TORX driver, remove the three screws from the large
keyboard.
Make sure that when you re-install these screws that you use the correct
parts. If longer screws are used, they can damage the front-panel label.
5
Press down on the top of the keyboard, and rotate the bottom of the
keyboard out.
To remove the handle
•
Rotate the handle down until it is just past the last detent position
(about 1/2 inch before the handle touches the bottom of the
oscilloscope), then pull the sides of the handle out of the cabinet.
Replacement Parts
To remove the keyboard
8-9