Specifications

Adjust the handle
Connect the cables
1
Check to ensure that you received everything that is supplied with
the oscilloscope.
2
Connect the oscilloscope to power and turn it on.
3
Connect the cables:
If you are using this model: Do this:
HP 54645A Oscilloscope
Connect the oscilloscope probe cables to oscilloscope
channels 1 and 2.
HP 54645D Mixed-Signal
Oscilloscope
Connect the oscilloscope probe cables to oscilloscope
analog channels A1 and A2.
Connect the digital probe cable to oscilloscope digital
channels D0-D15.
4
Then, connect the scope and/or digital probes to the circuit of
interest. Be sure to connect the ground leads.
You can use the front-panel calibration point as a stimulus while learning to
use the oscilloscope.
1
Grasp the handle pivot points on each side of the
instrument and pull the pivot out until it stops.
2
Without releasing the pivots, swivel the handle to
the desired position. Then release the pivots.
Getting Started
Adjust the handle
1-9