Specifications

Signal Centered on the Display

Press

Cursors

Set the Y2 cursor to the top of the signal, and set Y1 to the bottom of

the signal.

Note the

∆

Y value at the bottom of the display. In this example, we are using

the Y cursors, but you could have used the X cursors instead. If you use the

X cursors, make sure you center the signal in the Y axis.

Cursors Set on Displayed Signal

Figure 5-9

Figure 5-10

Making Measurements with HP 54645A/D Oscilloscopes

To use the XY display mode

5-15