Specifications

To initialize the label list
1
Press
Label/Threshold
.
2
Press the
Initialize Label List
softkey.
A message appears, warning you that this operation will overwrite the
current label list.
•
To confirm the operation, press the
Yes
softkey. You will be prompted to
press Yes again to initiate the operation.
•
To cancel the operation, press the
No
softkey.
When you first begin using the oscilloscope, there are some blank entries at
the beginning of the label list. As you define custom labels, these spaces are
filled. One blank space is always retained to allow entry of a new label. When
you initialize the label list, all of your custom labels will be cleared.
Using Labels on the Mixed-Signal Oscilloscope
To initialize the label list
4-58