Operating instructions

University of Saskatchewan
Electrical Engineering Laboratory Equipment Manual
Logic Analyzer ( Digital Channels )
The Logic Analyzer cable connects to the rear panel. Be Careful not to physically
Stress the cable. Route the cable around the side of the scope leaving plenty of slack at the rear
of the scope. Turn off the analog channels not in use. Push the D15 Thru D0 key. Turn off the
digital channels not used. Controls for the digital channels are the soft keys below the display,
three keys to the right of the display and the Trigger keys. The Thresholds soft key is used to set
the digital channel threshold.
Printing the Display
The display can be printed to a USB printer ( not available ) or to a USB mass storage
device. The USB storage device is available from the technicians in 2C94.
Push the Utility key and then the Print Config soft key.
Push the Print to Bmp (8-bit) soft key.
Push the Options soft key and select Invert Graticule Colors.
The scope is now set to store the display to the USB storage device.
Insert the USB storage device into the front connector.
Push the hard key Quick Print to save to the USB device. Load the file from the USB
device into a computer. Delete your files from the USB device before returning it to 2C94.