Specifications

Chapter 3 Replacing Assemblies
To Remove the Front Panel Assembly
182 Assembly-Level Service Guide
To Remove the Front Panel Assembly
1 Remove the cover and rear bezel from the counter as described
previously.
2 If installed, remove the Option 300 Internal DC Battery assembly
as described previously.
3 If installed, remove the GPIB assembly as described previously.
4 If installed, remove the Option 106 or 115 Microwave Channel
assembly as described previously.
5 To remove the front rubber bumper, stretch a corner and then
slide it off as shown in Figure 3-7.
Figure 3-7. Front Rubber Bumper Removal
6 Remove the front panel assembly as follows:
NOTE Read each instruction step in its entirety, while examining the
hardware and referring to the appropriate figure(s), before
proceeding with the step. This will acquaint you completely, in
advance, with the action to be performed. The actions in some
steps must be accomplished simultaneously to succeed. Read all
nearby NOTES carefully.