Specifications

Chapter 3 Replacing Assemblies
To Remove the Processor Board
Assembly-Level Service Guide 181
To Remove the Processor Board
1 Remove the cover and rear bezel as described previously.
2 Turn the chassis upside down. On the bottom of the motherboard,
remove the T10 TORX screw that secures the smaller Processor
printed circuit board to the motherboard (see Figure 3-6).
Figure 3-6. Processor PC Board
NOTE For re-assembly, note how the left rear corner of the Processor
board fits into its slot (above the small plastic standoff inside the
slot) to hold the board horizontal.
3 Press the two tabs securing the edge connector of the Processor
board to release the board.
4 Remove the Processor board carefully from its connector and set
it aside in a safe location on the ESD mat.
5 To re-install the Processor board, reverse the above procedure.
Slot
T10 Motherboard
Processor