Instruction manual

Chapter 3 Programming Your Counter for Remote Operation
Status Reporting
3-40 Programming Guide
3
• Bits 6-11 are not used.
• Bit 12 (Hardware Summary) This condition is TRUE when an
internal hardware fault has been detected, either in normal operation
or by the self test.
• Bit 13 is not used.
• Bit 14 (Command Warning) is an event bit indicating a command,
such as CONFigure or MEASure, ignored a parameter during
execution.
Since this is an event bit, the transition filters have no effect on it.
• Bit 15 is not used.