Instruction manual

Chapter 2 Command Summary
Agilent 53150A/151A/152A Command Summary
2-14 Programming Guide
2
___________________________________
*<source_list> has the same syntax as SCPI <channel_list>. For example, a frequency
measurement on channel 2 uses (@2) to specify channel 2.
Table Agilent 53150A/151A/152A SCPI Command Summary (Continued)
Keyword/Syntax Parameter Form Std/New Comments
Measurement Instructions
:CONFigure[:SCALar]:<function>
:CONFigur e?
:MEASure:[:SCALar]:<function>?
:READ[:SCALar]:<function>?
:FETCh[:SCALar]:<function>?
See <parameters> and
<source_list> below.
See <parameters> and
<source_list> below.
Std
Std
Std
Std
Std
Configures the instrument
to perform the specified
measurement.
Returns the function
configured by the last
:CONFigure or :MEASure
command.
Configures the instrument,
initiates measurement,
and queries for the result
(i.e., provides a complete
measurement sequence.
Initiates measurement,
and queries for the result.
(Performs a :FETCh? on
“fresh” data.)
Queries the measurement
made by a previous
:MEASure, :READ, or
:INITiate command.
*The <function> and corresponding <parameters> and <source_list> are defined below:
<function> <parameters> [,<source_list>]* Std/New
[:VOLTage]:FREQuency
:POWer[:AC]
[<expected_value>[,<r
esolution>]]
[<expected_value>[,<r
esolution>]]
[,(@1) | (@2)]
[,(@2)]
Std
Std