Instruction manual

Chapter 4 Command Reference
Common Commands
Programming Guide 4-45
4
*ESE (Standard Event Status Enable Command)
*ESE? (Standard Event Status Enable Query)
COMMAND *ESE <NRf> | <non-decimal numeric>
*ESE?
Sets or queries the Standard Event Status Enable Register, shown in
Figure 4-3.
The parameter and query response value, when rounded to an integer
value and expressed in base 2 (binary), represents the bit values of the
Standard Event Status Enable Register. The value of unused bits is zero
when queried and ignored when set.
This register is used to enable a single or inclusive OR group of Standard
Event Status Register events to be summarized in the Status Byte
Register (bit 5).
Figure 4-3. The Standard Event Status Enable Register
See the section titled “Standard Event Status Register” on Page 3-30 of
this guide for a detailed description of the Standard Event Status
Register.
(
1
)
Operation Complete
Not Used
(
4
)
Query Error
2
(
8
)
Device Dependent Error
3
(
16
)
Execution Error
4
(
32
)
Command Error
5
Not Used
6
(
128
)
Power On
7
Bits
0
1