Instruction manual

Chapter 4 Command Reference
[:SENSe]:FUNCtion Subtree
Programming Guide 4-29
4
COMMAND [:SENSe]:FUNCtion:STATe? . . . <sensor_function>
This query-only command returns a Boolean value that indicates whether
the specified <sensor_function> is currently ON or OFF.
COMMENT See [:SENSe]:FUNCtion[:ON] on Page 4-28 for valid <sensor_function>
strings.
[:SENSe]:POWer Subtree
This subtree controls the power-measurement function.
COMMAND [:SENSe]:POWer:AC:REFerence . . . <numeric_value><power_units>
This command sets a reference amplitude (in dB) for display of power
measurements. It is intended for use as a measurement offset, so that a
measurement can be referenced to a known value.
RANGE –50 dBm to 10 dBm
UNITS dB, dBm
COMMENT *RST: 0
RELATED
FRONT-PANEL
KEYS
Shift + Pwr Offset
COMMAND [:SENSe]:POWer:AC:REFerence:STATe . . . <Boolean>
Determines whether amplitude is measured in absolute or relative mode.
If STATe is ON, amplitude is referenced to the value set in REFerence.
COMMENT *RST: OFF
RELATED
FRONT-PANEL
KEYS
Power Offset On/Off