User`s guide

17
Command Description
LN Linear units (watts/%)
LP2 Learn mode
LT
1
Left arrow key
MZ Megahertz
OC0 Reference oscillator off
OC1 Reference oscillator on
OD Output display
OF0 Offset off
OF1 Offset on
OS Enter offset value
PCT Percent
PR Preset
RA Auto range
RC Recall instrument configuration
RE Set display resolution
RF Enter sensor table reference alibration factor
RH Range hold
RL0 Exit from relative mode
RL1 Enter relative mode (take new reference)
RL2 Enter relative mode (use last reference)
RM Set measurement range
*RST Reset
Command Description
RT
1
Right arrow key
RV Read service request mask
SE Select sensor calibration table
SM Status message
SN Enter sensor identification/serial number
SP
1
Special
SPD 20 | 40
2
*SRE Set the service request mask
*SRE? Service request mask query
ST Store (save) power meter configuration
*STB? Read status byte
SYST:LANG Selects SCPI language
SCPI
3
TR0 Trigger hold
TR1 Trigger immediate
TR2 Trigger with delay
TR3 Trigger free run
*TST?
4
Self test query
UP Up arrow key
ZE Zero
@1 Prefix for status mask
@2 Learn mode prefix
% Percent
1. This command is accepted but has no active function.
2. This command is not an original 437B command. However, it can be used
to set the measurement speed to 20 or 40 readings/sec in 437B mode.
3. This command is not an original 437B command. However, it can be used
to terminate the 437B language and select the SCPI language. Note that it is
recommended that the instrument is preset following a language switch.
4. Always returns 0000 in 437B language.