Specifications
38
Chapter 3: Testing Performance
To Set up the Test Equipment and the Analyzer
To Set up the Test Equipment and the Analyzer
Before testing the specifications of the 16740/41/42A logic analyzer, the test
equipment and the logic analysis system must be set up and configured.
These instructions include detailed steps for initially setting up the required test
equipment and the logic analysis system. Before performing any or all of the
following tests in this chapter, the following steps must be followed.
NOTE: Multi-card modules must be separated into single-card modules.
Equipment Required
Set up the equipment
1 Turn on the required test equipment listed in the table above. Let them
warm up for 30 minutes before beginning any test.
2 Turn on the logic analysis system.
a Connect the keyboard, mouse, and monitor to the rear panel of the
logic analysis system mainframe (16700B only).
b Plug in the power cord to the power connector on the rear panel of the
mainframe.
c Turn on the main power switch on the mainframe front panel.
3 Set up the logic analysis system.
a Open the Session Manager window and select “Start Session”.
b In the Logic Analysis System window, select the module icon, then
select Setup. A Setup window opens.
c In the Setup window, select Window, then select Slot n: Analyzer<n>
(where “n” is the slot the module under test is installed), then select
Listing. A Listing window opens.
(TXLSPHQW &ULWLFDO6SHFLILFDWLRQV
5HFRPPHQGHG+3$JLOHQW
0RGHO3DUW
3XOVH*HQHUDWRU 0K]QVSXOVHZLGWKSVULVHWLPH $RSWLRQ
'LJLWL]LQJ2VFLOORVFRSH ≥*+]EDQGZLGWKSVULVHWLPH $Z$
'LJLWDO0XOWLPHWHU P9UHVROXWLRQDFFXUDF\ $
)XQFWLRQ*HQHUDWRU '&RIIVHWYROWDJH9 %2SWLRQ