Specifications

Chapter 2: Preparing for Use

3 Connect a 2x40 cable to J9 and to J10 of each card in the multicard

configuration.

4 On the expander cards, disconnect the end of the 2x10 cable that is

plugged into the connector labeled "Master."

CAUTION: If you pull on the flexible ribbon part of the 2x10 cable, you might damage the cable

assembly. Using your thumb and finger, grasp the ends of the cable connector. Apply

pressure to the ends of the cable connector to disengage the metal locking tabs of the

connector from the cable socket on the board. Then pull the connector from the cable

socket.