Specifications

18
Chapter 2: Preparing for Use
4 Starting from the top, pull the cards and filler panels that need to be
moved halfway out.
CAUTION: All multi-card modules will be cabled together. Pull these cards out together.
5 Remove the cards and filler panels.
Remove the cards or filler panels that are in the slots intended for the module
installation. Push all other cards into the card cage, but not completely in. This is
to get them out of the way for installing the module.
Some modules for the Logic Analysis System require an operational accuracy
calibration if you move them to a different slot. For calibration information, refer
to the manuals for the individual modules.
To configure a one-card module
• When shipped separately, the module is configured as a one-card module. The cables
should be connected as shown in the figure.
• To configure a multicard module into one-card modules, remove the cables
connecting the cards. Then connect the free end of the 2x10 cable to the connector
labeled "Master" (J6) on each card (see figure below).
CAUTION: If you pull on the flexible ribbon part of the 2x10 cable, you might damage the cable
assembly. Using your thumb and finger, grasp the ends of the cable connector. Apply
pressure to the ends of the cable connector to disengage the metal locking tabs of the
connector from the cable socket on the board. Then pull the connector from the cable
socket.
NOTE: Save unused cables for future configurations.