Specifications

133
Chapter 5: Troubleshooting
To test the cables
This test allows you to functionally verify the probe cable and probe tip assembly
of any of the logic analyzer pods. Only one probe cable can be tested at a time.
Repeat this test for each probe cable to be tested.
Equipment Required
1 If you have not already done so, do the procedure "“To Set up the Test
Equipment and the Analyzer” on page 38 in Chapter 3.
2 Set up the pulse generator.
a Set up the pulse generator according to the following table
Pulse Generator Setup
b Enable the pulse generator channel 1 and channel 2 outputs (LED off).
(TXLSPHQW &ULWLFDO6SHFLILFDWLRQ
5HFRPPHQGHG+3
$JLOHQW0RGHO3DUW
3XOVH*HQHUDWRU 0+]QVSXOVHZLGWK
SVULVHWLPH
$2SWLRQ
[7HVW&RQQHFWRUV4W\
7LPHEDVH &KDQQHO &KDQQHO 7ULJJHU
0RGH,QW
3HULRGQV
0RGH6TXDUH
'HOD\QV
+LJK9
/RZ9
&203'LVDEOHG
/('2II
0RGH6TXDUH
'HOD\QV
+LJK9
/RZ9
&203'LVDEOHG
/('2II
'LYLGH'LYLGH÷ 
$PSO9
2IIV9