Service manual

84 3
Adjustment
Preparation for using the Adjustment Program
Preparation for using the Adjustment Program
To use the Adjustment Program, some preparation is required. This section describes how
to its procedure.
Installing an GPIB Card (82340, 82341 or 82350)
Install an GPIB Card into your computer (see the GPIB Card manual). The select code of
the GPIB Card should be set to “7”.
Installing HP VEE for Personal Computer
Install the HP VEE into your computer (see the HP VEE for Windows
®
).
Installing Adjustment Program into Your PC (preliminary)
1. Make a copy of the 4294A adjustment program named ADJ4294A.EXE in a directory
of your harddisk drive.
2. Double-click the filename on the Windows’Explorer to start extracting the
self-extracting archive.
3. You will be prompted to enter directory name for installing the program files. Click
Unzip to use default directory (C:\ADJ4294A).
4. Confirm the message that you successfully extract the files and click OK and Close.
Equipment Setup
Performing adjustments requires the system described in this section. The Hardware Setup
is shown in
Figure 3-1.