Service manual

46 2

Performance Test

torque. (A 1/2 inch open end wrench may be necessary to hold the airline

stationary.)

Figure 2-14 10 cm Airline with SHORT Measurement Test Setup

32. Press [Trigger] - Single to make a measurement.

33. Record the 4294A reading on the calculation sheet for all setting in Table 2-11 on page

45, then calculate the test result.

34. Disconnect all the equipment from the 4294A, then perform the setup as follows

a. Connect the 1m Test Leads to the 4294A UNKNOWN Terminal.

b. Press [Cal] - ADAPTER - 4TP 1M - SETUP.

c. Connect the 100 Ω Resistor to 1m Test Leads as shown in Figure 2-15.