Specifications

Chapter 6 81
Retrieving Measurement Results
Internal Data Processing
6. Retrieving Measurement
Results
NOTE When setting calibration coefficients, note the following:
• To ensure that the instrument will provide correct measurement results, you must first
configure the instrument to use the same measurement points (point setup table
settings) as when you obtained measurement data for calibration and then set all the
coefficients.
• You must turn on the calibration functions before setting the calibration coefficients.
Compensation Data Arrays
As shown in the table below, the instrument has two Compensation Data Arrays
corresponding to the OPEN and SHORT standards. Each Compensation Data Array
contains the standard measurement data (complex numbers) necessary for calculating the
compensation coefficients.
To retrieve one of the Compensation Data Arrays, use the following command:
• :DATA:CMD{1-2}? on page 261
Compensation Coefficient Arrays
As shown in the table below, the instrument has three Compensation Coefficient Arrays
corresponding to compensation coefficients A, B, and C. Each Compensation Coefficient
Array contains the compensation coefficients (complex numbers) calculated based on the
Compensation Data Array.
To retrieve one of the Compensation Coefficient Arrays, use the following command:
• :DATA:CMP{1-3} on page 262
NOTE When setting compensation coefficients, note the following:
• To ensure that the instrument will provide correct measurement results, you must first
configure the instrument to use the same measurement points (point setup table
settings) as when you obtained measurement data for compensation and then turn on
the calibration functions before setting the coefficients.
• You must turn on the compensation functions before setting the compensation
coefficients.
Array number
*1
Indicated data
1 OPEN measurement data for calculating the compensation coefficients
2 SHORT measurement data for calculating the compensation coefficients
*1.Use this number as the suffix to the command.
Array number
*1
Indicated data
1 Compensation coefficient A
2 Compensation coefficient B
3 Compensation coefficient C
*1.Use this number as the suffix to the command.