Specifications

Appendix E 349
4286A vs. 4287A GPIB Commands Correspondence Table
4286A vs. 4287A GPIB Commands Correspondence Table
2. Chapter Title 3. Chapter Title
4. Chapter Title
5. Chapter Title
E. 4286A vs. 4287A GPIB Commands Correspondence Tab l e
Trigger Release Trigger *TRG :TRIG on page 308
*TRG on page 208 (with Query
response)
Set Trigger Event Mode :TRIG:EVEN:TYPE None.
Set Trigger Source :TRIG:SOUR ¬on page 310
Set Polarity of External Trigger :TRIG:SLOP ¬on page 309
Set Delay Time Trigger Delay
(for each
trigger)
:SENS:SWE:DWEL2 :TRIG:DEL on page 308
Point Delay
(for each point)
:SENS:SWE:DWEL1 :TRIG:SEQ2:DEL on page 309
Trigger System Reset :ABOR ¬on page 209
Initiate Once :INIT ¬on page 287
Reset and then
Reinitiate
:INIT:AGA:ALL None.
Set Continuous
Start ON/OFF
:INIT:CONT ¬on page 287
Data
Read/Write
Set Data Transfer Format :FORM ¬on page 282
Set Byte Order for Binary Transfer None. :FORM:BORD on page 283
Read Results of Impedance
Measurement (complex number
data before
calibration/compensation)
:DATA? RAW :DATA:RAW? on page 264
Read Results of Impedance
Measurement (complex number
data after calibration/compensation
and before parameter conversion)
:DATA? DATA None.
Read Measurement Results of
Measurement Parameters
:DATA? DTR :DATA:FDAT{1-4}? on page 263
Read Results of R
dc
Measurement :DATA? RDC :DATA:RDC? on page 267
Read Results of R
dc
Comparator
Decision
:DATA? RDCL :CALC:COMP:DATA:RDC? on
page 222
Read Results of R
dc
Comparator
Decision, R
dc
Measurement, and
Measurement Parameter
:DATA? RDCDT None.
(The equivalent information can be
obtained with :FETC? on page 280 or
:READ? on page 293.)
Read Results of Monitoring Test
Signal Level
:DATA? MON :DATA:IMON? on page 263
:DATA:VMON? on page 267
Function Item to set/run
GPIB command
4286A 4287A