Specifications

Appendix E 345
4286A vs. 4287A GPIB Commands Correspondence Table
4286A vs. 4287A GPIB Commands Correspondence Table
2. Chapter Title 3. Chapter Title
4. Chapter Title
5. Chapter Title
E. 4286A vs. 4287A GPIB Commands Correspondence Tab l e
Function Item to set/run
GPIB command
4286A 4287A
Measurement
settings
Reset Trigger System
Consecutive Start
Off
*RST ¬on page 206
Trigger System
Consecutive
Initiation On
:SYST:PRES ¬on page 306
Measurement Parameter Setting :CALC:FORM :CALC:PAR{1-4}:FORM on page 230
Set
Measurement
Points and Test
Signal
Set Test Signal
Level
:SOUR:POW
:SOUR:CURR
:SOUR:VOLT
(Because these differ in how they are
used, there is no one-to-one
correspondence between the two
machines’ commands.)
:SOUR:LIST on page 294
:SOUR:UNIT on page 298
:SOUR:LIST:CLE on page 295
:SOUR:LIST:STAT on page 297
:SOUR:LIST:POIN on page 295
:SOUR:LIST:TABL on page 297
:AVER:COUN on page 210
Set List Table :SENS:LIST:CLE
:SENS:LIST:MODIF:SEGM{1-10}:FREQ
:SENS:LIST:MODIF:SEGM{1-10}:AVER:COUN
:SENS:LIST:SAVE :SENS:LIST:SEGM
:SENS:LIST:SEGM:ADD
:SENS:LIST:SEGM:AVER:COUN
:SENS:LIST:SEGM:DEL
:SENS:LIST:SEGM:EDIT
:SENS:LIST:SEGM:FREQ
:SENS:LIST:SEGM:QUIT
:SENS:LIST:SEGM:SAVE
Set R
dc
Measurement
Measurement
ON/OFF
:SENS:RDC :SOUR:LIST:RDC on page 296
Comparator
ON/OFF
:CALC:RDC:LIM:STAT None.
(This is done by turning ON/OFF the
entire function of the comparator.)
Limit Value :CALC:RDC:LIM:UPP
:CALC:RDC:LIM:LOW
:CALC:COMP:RDC:LIM on page 224
Set Delay Time Trigger Delay
(for each trigger)
:SENS:SWE:DWEL2 :TRIG:DEL on page 308
Point Delay :SENS:SWE:DWEL1 :TRIG:SEQ2:DEL on page 309