Specifications

Appendix B 325
Status Reporting System
Using the Status Reporting System
B. Status Reporting System
Using the Status Reporting System
You can manage the status report system using the following commands in any
combination:
• *CLS on page 204
• *SRE on page 207
• *STB? on page 207
• *ESE on page 204
• *ESR? on page 205
• :STAT:PRES on page 301
• :STAT:OPER:ENAB on page 299
• :STAT:OPER:COND? on page 299
• :STAT:OPER? on page 299
• :STAT:OPER:PTR on page 300
• :STAT:OPER:NTR on page 300
• :STAT:QUES? on page 301
• :STAT:QUES:ENAB on page 301
For sample programs that demonstrate the use of the commands listed above, refer to
“Waiting for (Detecting) End of Measurement” on page 70 in Chapter 5 or “Using the
Status Reporting System” on page 135 in Chapter 10.
NOTE You cannot use the *STB? command in telnet session. Refer Figure B-3, “Status Register
Structure,” and use the command to read lower level registers of the status byte register.