Specifications

Chapter 16 309
Command Reference
:TRIG:SEQ2:DEL
16. Command Reference
:TRIG:SEQ2:DEL
Syntax :TRIGger:SEQuence2:DELay <numeric>
:TRIGger:SEQuence2:DELay?
Description Specifies the pre-measurement wait time (measurement point delay time) for each
measurement point.
Parameters
If your specified parameter is beyond the valid range, the instrument ignores the parameter
and uses either the maximum or minimum value depending on whether the parameter is
greater than the upper limit or smaller than the lower limit.
Query Response {numeric}<newline><^END>
See also :TRIG:DEL on page 308
Equivalent key
sequence
[Trigger Mode] - SETUP DELAY - POINT DELAY
:TRIG:SLOP
Syntax :TRIGger:SLOPe {POSitive|NEGative}
:TRIGger:SLOPe?
Description Sets the polarity of the external trigger signal input through the rear panel EXT TRIGGER
terminal and the handler interface.
Parameters
Query Response {POS|NEG}<newline><^END>
Equivalent key
sequence
[Trigger Mode] - TRIG PRLTY
<numeric>
Description Measurement point delay time
Range 0 to 1
Default 0
Unit s (seconds)
Resolution 100E-6
Description
POSitive
(initial value)
Positive (triggering at the rising edge from the LOW level to the
HIGH level)
NEGative Negative (triggering at the falling edge from the HIGH level to
the LOW level)