Specifications

308 Chapter 16
Command Reference
:TRIG
:TRIG
Syntax :TRIGger[:SEQuence1][:IMMediate]
Description When the trigger system is in trigger event detect state, you can use this command to
immediately trigger the instrument to start measurement, regardless of the trigger setting. If
the trigger system is not in trigger event detect state, however, issuing the command
generates an error. For more information on the trigger system, see “Trigger system” on
page 66. (No query)
Equivalent key
sequence
No equivalent keys are available on the front panel.
:TRIG:DEL
Syntax :TRIGger[:SEQuence1]:DELay <numeric>
:TRIGger[:SEQuence1]:DELay?
Description Specifies the wait time (trigger delay time) between triggering and the start of single-point
or list measurement.
Parameters
If your specified parameter is beyond the valid range, the instrument ignores the parameter
and uses either the maximum or minimum value depending on whether the parameter is
greater than the upper limit or smaller than the lower limit.
Query Response {numeric}<newline><^END>
See also :TRIG:SEQ2:DEL on page 309
Equivalent key
sequence
[Trigger Mode] - SETUP DELAY - TRIGGER DELAY
<numeric>
Description Trigger delay time
Range 0 to 1
Default 0
Unit s (seconds)
Resolution 100E-6