Specifications

30 Chapter 3
Specifying Measurement Conditions
Configuring Screen Display
Configuring Screen Display
Configuring the display of measurement results
Showing/hiding all measurement results
You can instruct the instrument to show or hide the entire set of measurement results,
which includes the measurement results for measurement parameters 1 through 4, test
signal level monitoring, and R
dc
measurement). To do so, use the following command:
• :DISP:TEXT1 on page 269
Configuring the display of Individual values
You can set the following display attributes for each value:
• Number of digits
• Whether to fix the decimal point
• Most significant digit when the value is displayed with the decimal point fixed
• Whether to show or hide the value
To set the above display attributes, use the commands listed in the table below.
Results for measurement
parameters
:CALC1: parameter 1
:CALC2: parameter 2
:CALC3: parameter 3
:CALC4: parameter 4
Result of test signal level
monitoring
:CALC11: current level
:CALC12: voltage level
Result of R
dc
measurement
Number of digits :DISP:TEXT1:CALC{1-4}:DIG
on page 270
:DISP:TEXT1:CALC{11-12}:DIG
on page 272
:DISP:TEXT1:CALC13:DIG
on page 274
Whether to fix
decimal point
:DISP:TEXT1:CALC{1-4}:FIX
on page 271
:DISP:TEXT1:CALC{11-12}:FIX
on page 273
:DISP:TEXT1:CALC13:FIX
on page 274
Most significant
digit when
decimal point is
fixed
:DISP:TEXT1:CALC{1-4}:MSD
on page 271
:DISP:TEXT1:CALC{11-12}:MSD
on page 273
:DISP:TEXT1:CALC13:MSD
on page 275
Whether to show
or hide value
:DISP:TEXT1:CALC{1-4} on
page 270
:DISP:TEXT1:CALC{11-12} on
page 272
:SOUR:LIST:RDC on
page 296
*1
*1.This command not only sets whether to show or hide the result of R
dc
measurement but also whether
to turn on or off the R
dc
measurement function. You cannot use the command to only show or hide the
R
dc
result.