Specifications

280 Chapter 16
Command Reference
:FETC?
:FETC?
Syntax :FETCh?
Description Returns the measurement data from the most recently performed measurement. (Query
only)
Query response For single-point measurement
{stat},{par1},{par2},{par3},{par4},{Imon},{Vmon},{Rdc},{comp}<newline><^END>
The command returns the following data at the measured point.
{stat}: Measurement status, which is represented as an integer between 0 and
3 as follows:
0: No error
1: Detection of measurement failure (overload)
2: Detection of R
dc
out of range
3: Simultaneous detection of overload and R
dc
out of range
{par1}: Parameter 1 measurement result
{par2}: Parameter 2 measurement result
{par3}: Parameter 3 measurement result
{par4}: Parameter 4 measurement result
{Imon}: Result of monitoring test signal current level
{Vmon}: Result of monitoring test signal voltage level
{Rdc}: Result of R
dc
measurement.
{comp}: Bin sort result, which can be an integer between 0 and 14 as follows:
0: Indicates a DUT that was not sorted into any of bins 1 through 13
1: Sorted into bin 1
2: Sorted into bin 2
3: Sorted into bin 3
4: Sorted into bin 4
5: Sorted into bin 5
6: Sorted into bin 6
7: Sorted into bin 7
8: Sorted into bin 8
9: Sorted into bin 9
10: Sorted into bin 10
11: Sorted into bin 11
12: Sorted into bin 12
13: Sorted into bin 13
14: Sort failed
NOTE The result of parameter 1 is not returned if the display of parameter 1 is off. The results of
parameters 2 through 4 as well as the test signal current/voltage levels are treated in a
similar way.
The result of R
dc
measurement is not returned if the R
dc
measurement feature is off.