Specifications

Chapter 16 263

Command Reference

:DATA:FDAT{1-4}?

16. Command Reference

:DATA:FDAT{1-4}?

Syntax :DATA[:DATA]:FDATa{1|2|3|4}?

Description Returns the display data array for one of parameters 1 (:FDAT1) through 4 (:FDAT4). This

array contains the display data obtained by performing measurement parameter conversion

and data operations on the corresponding data array (see “Display Data Arrays” on

page 79).

If the measurement fails because of overload, the command returns 9.9E37. (Query only)

Query response For single-point measurement

{numeric}<newline><^END>

The command returns the value (real number) of the measured point.

For list measurement

{numeric 1},...,{numeric N}<newline><^END>

The command returns as many values (real numbers) as the measurement points defined in

the active table, in the order of measurement point numbers.

Equivalent key

sequence

No equivalent keys are available on the front panel.

:DATA:IMON?

Syntax :DATA[:DATA]:IMON?

Description Returns the result of monitoring the current level of the test signal. If the measurement

failed because of overload, the command returns 9.9E37. (Query only)

Query response For single-point measurement

{numeric}<newline><^END>

The command returns the monitored value (real number) of the measured point.

For list measurement

{numeric 1},...,{numeric N}<newline><^END>

The command returns the monitored value (real number) at each point defined in the active

table. Therefore, the returned data contains as many monitored values as the number of

measurement points (N) and is sent in the order of measurement point numbers.