Specifications

26 Chapter 3

Specifying Measurement Conditions

Setting Measurement Parameters

You can assign measurement parameters 1 through 4 (:PAR1, :PAR2, :PAR3, and :PAR4)

independently of the other parameter settings. To set measurement parameters, use the

following command:

• :CALC:PAR{1-4}:FORM on page 230

You can configure the instrument to measure the parameters shown in the table below:

Parameter

Parameter label

on screen

Description

Z |Z| Impedance amplitude (absolute value)

Y |Y| Admittance amplitude (absolute value)

LS Ls Equivalent series inductance

LP Lp Equivalent parallel inductance

CS Cs Equivalent series capacitance

CP Cp Equivalent parallel capacitance

RS Rs Equivalent series resistance

RP Rp Equivalent parallel resistance

Q Q Q value (inverse of dissipation factor)

D D Dissipation factor

X X Equivalent series reactance

G G Equivalent parallel conductance

B B Equivalent parallel susceptance

TZR qz (rad) Impedance phase (in radians)

TZD qz (deg) Impedance phase (in degrees)

TYR qy (rad) Admittance phase (in radians)

TYD qy (deg) Admittance phase (in degrees)