Specifications

Chapter 16 251

Command Reference

:CORR2:CKIT:STAN2:LIST

16. Command Reference

:CORR2:CKIT:STAN2:LIST

Syntax [:SENSe]:CORRection2:CKIT:STANdard2:LIST <numeric 1>,<numeric 2>,<numeric 3>

[:SENSe]:CORRection2:CKIT:STANdard2:LIST? <numeric 1>

Description Defines the equivalent series resistance (Rs) and equivalent series inductance (Ls) values at

a specified measurement point, for the SHORT standard of the compensation kit.

If you have issued the :CORR2:CKIT:LIST command by specifying “OFF” to configure

the instrument to accept fixed-value definitions for each standard of the user-defined

calibration kit, specifying a particular measurement point has no effect; regardless of the

measurement point number specified, the same value is applied to all measurement points.

Similarly, when you issue this command in its query form, the command returns the same

value regardless of the value you assign to a particular measurement number. Nevertheless,

you must specify a valid measurement point number (for example, “1”) so that the

command can successfully execute.

Parameters

If your specified parameter is beyond the valid range, the instrument ignores the parameter

and uses either the maximum or minimum value depending on whether the parameter is

greater than the upper limit or smaller than the lower limit.

Query response {numeric 2},{numeric 3}<newline><^END>