Specifications

242 Chapter 16

Command Reference

:CORR1:CKIT:STAN3:LIST

Syntax [:SENSe]:CORRection1:CKIT:STANdard3:LIST <numeric 1>,<numeric 2>,<numeric 3>

[:SENSe]:CORRection1:CKIT:STANdard3:LIST? <numeric 1>

Description Defines the impedance values at a specified measurement point for the LOAD standard

values of the user-defined calibration kit. To specify the parameter type to use when

defining the LOAD standard values, use the :CORR1:CKIT:STAN3:FORM command to

instruct the instrument to accept definitions based on equivalent series resistance (Rs) and

equivalent series inductance (Ls) values; equivalent series inductance (Ls) and quality

factor (Q) values: or equivalent parallel capacitance (Cp) and dissipation factor (D) values.

If you have issued the :CORR1:CKIT:LIST command by specifying “OFF” to configure

the instrument to accept fixed-value definitions for each standard of the user-defined

calibration kit, specifying a particular measurement point has no effect; regardless of the

measurement point number specified, the same value is applied to all measurement points.

Similarly, when you issue this command in its query form, the command returns the same

value regardless of the value you assign to a particular measurement number. Nevertheless,

you must specify a valid measurement point number (for example, “1”) so that the

command can successfully execute.

Parameters • Definitions based on Rs and Ls values

• Definitions based on Ls and Q values

Description Measurement point number Rs Ls

Range 1 to number of points (up to

32)

-1E6 to 1E6 -1E6 to 1E6

Default 1 50 0

Unit None W (ohm) H (henry)

Resolution 1 1E-18 1E-18

Description Measurement point number Ls Q

Range 1 to number of points (up to

32)

-1E6 to 1E6 -1E6 to 1E6

Default 1 0 0

Unit None H (henry) None

Resolution 1 1E-18 1E-18