Specifications

Chapter 16 239
Command Reference
:CORR1:CKIT:STAN3:DC
16. Command Reference
:CORR1:CKIT:STAN3:DC
Syntax [:SENSe]:CORRection1:CKIT:STANdard3:DC <numeric>
[:SENSe]:CORRection1:CKIT:STANdard3:DC?
Description Defines the dc resistance (R
dc
) value of the LOAD standard of the user-defined calibration
kit.
Parameters
If your specified parameter is beyond the valid range, the instrument ignores the parameter
and uses either the maximum or minimum value depending on whether the parameter is
greater than the upper limit or smaller than the lower limit.
Query response {numeric}<newline><^END>
See also :CORR1:CKIT:STAN1:DC on page 233
:CORR1:CKIT:STAN2:DC on page 236
Equivalent key
sequence
[Setup View] (Calibration kit setup display)
<numeric>
Description R
dc
Range -1E6 to 1E6
Default 50
Unit W (ohm)
Resolution 1E-18