Specifications

232 Chapter 16
Command Reference
:CORR1:CKIT:LIST
:CORR1:CKIT:LIST
Syntax [:SENSe]:CORRection1:CKIT:LIST[:STATe] {ON|OFF|1|0}
[:SENSe]:CORRection1:CKIT:LIST[:STATe]?
Description Specifies whether the instrument should allow each standard of the user-defined calibration
kit to be defined on a point-by-point basis or based on a fixed value that does not depend
on a particular measurement point. In the latter case, the same value is applied to all
measurement points.
If the instrument has already been configured to accept point-by-point definitions, using
this command to reconfigure it to use a fixed value changes the standard values of all
measurement points to that of measurement point number 1.
Parameters
Query response {1|0}<newline><^END>
Equivalent key
sequence
[Setup View] (Calibration kit setup display)
Description
ON or 1 Configures instrument to accept point-by-point definitions
OFF or 0
(initial value)
Configures instrument to accept definitions based on a fixed
value (the same value is applied to all measurement points)