Specifications

218 Chapter 16

Command Reference

:CALC:COMP:COND{1-4}:SNUM

Syntax :CALCulate:COMParator:CONDition{1|2|3|4}:SNUMber <numeric>

:CALCulate:COMParator:CONDition{1|2|3|4}:SNUMber?

Description Lets you specify the measurement point for each of the four sorting conditions (:COND1

through :COND4). This setting applies to all of the bins.

This setting is reset when settings in the measurement point setup table are changed by

execution of :SOUR:LIST or :SOUR:LIST:CLE commands.

Parameters

If your specified parameter is beyond the valid range, the instrument ignores the parameter

and uses either the maximum or minimum value depending on whether the parameter is

greater than the upper limit or smaller than the lower limit.

Query response {numeric}<newline><^END>

See also :CALC:COMP:COND{1-4}:PAR on page 217

:SOUR:LIST on page 294

:SOUR:LIST:CLE on page 295

Equivalent key

sequence

[Setup View] (Bin sort setup display)

Description Point number

Range 1 to number of points (up to 32)

Default 1

Resolution 1