Specifications

Chapter 16 217
Command Reference
:CALC:COMP:COND{1-4}:PAR
16. Command Reference
:CALC:COMP:COND{1-4}:PAR
Syntax :CALCulate:COMParator:CONDition{1|2|3|4}:PARameter {Z|Y|LS|LP|CS|CP|RS|RP|Q|D|X|G|B|TZR|TZD|TYR|TYD}
:CALCulate:COMParator:CONDition{1|2|3|4}:PARameter?
Description Lets you specify the measurement parameter for evaluating each of the four sorting
conditions (:COND1 through :COND4). This setting applies to all of the bins.
Parameters
Sorting condition 1 defaults to Z; sorting condition 2 defaults to TZD; sorting condition 3
defaults to RS; sorting condition 4 defaults to X.
Query response {Z|Y|LS|LP|CS|CP|RS|RP|Q|D|X|G|B|TZR|TZD|TYR|TYD}<newline><^END>
See also :CALC:COMP:COND{1-4}:SNUM on page 218
Equivalent key
sequence
[Setup View] (Bin sort setup display)
Description
Z Evaluates the impedance amplitude absolute value
Y Evaluates the admittance amplitude absolute value
LS Evaluates the equivalent series inductance
LP Evaluates the equivalent parallel inductance
CS Evaluates the equivalent series capacitance
CP Evaluates the equivalent parallel capacitance
RS Evaluates the equivalent series resistance
RP Evaluates the equivalent parallel resistance
D Evaluates the dissipation factor
Q Evaluates the Q value (inverse dissipation factor)
X Evaluates the equivalent series reactance
G Evaluates the equivalent parallel conductance
B Evaluates the equivalent parallel susceptance
TZR Evaluates the impedance phase (in radians)
TZD Evaluates the impedance phase (in degrees)
TYR Evaluates the admittance phase (in radians)
TYD Evaluates the admittance phase (in degrees)