Specifications

216 Chapter 16
Command Reference
:CALC:COMP:COND{1-4}:NOM
:CALC:COMP:COND{1-4}:NOM
Syntax :CALCulate:COMParator:CONDition{1|2|3|4}:NOMinal <numeric>
:CALCulate:COMParator:CONDition{1|2|3|4}:NOMinal?
Description Lets you specify the limit range reference value that applies to each of the four sorting
conditions (:COND1 through :COND4). The reference value applies to all of the bins if
you have issued the :CALC:COMP:COND{1-4}:MODE command by specifying “DEV”
or “PCNT” to configure the instrument to accept a limit range in deviation or percent
mode.
Parameters
If your specified parameter is beyond the valid range, the instrument ignores the parameter
and uses either the maximum or minimum value depending on whether the parameter is
greater than the upper limit or smaller than the lower limit.
Query response {numeric}<newline><^END>
See also :CALC:COMP:COND{1-4}:MODE on page 215
Equivalent key
sequence
[Setup View] (Bin sort setup display)
<numeric>
Description Limit range reference value
Range -1E20 to 1E20
Default 0
Unit Depends on measurement parameter used to sort DUTs.
Resolution 1E-20